Recently Updated Pages
Information Reference
https://www.cisco.com/web/ANZ/cpp/refguide/hview/router/2800.html#cisco2821 https://www.cisco.co...
Information Reference
Cisco Aironet Series 2800/3800 Access Point Deployment Guidehttps://www.cisco.com/c/en/us/td/docs...
Information Reference
Cisco 5500 Series Wireless Controllershttps://www.cisco.com/c/en/us/support/wireless/5500-series-...
Proxmox VE 9.0 - Introduction
Introduction Proxmox Virtual Environment (VE) is a platform to run virtual machines and cont...
Topton X2E mini PC - Hardware Review
Introduction The Topton X2E (Intel N150 variant) is a compact, fanless mini PC designed prim...
Proxmox VE 9.0 - Installation
Proxmox VE is based on Debian. The installer will guide you through the setup, allowing you to ...
Proxmox VE 9.0 - Network Interfaces
Introduction Proxmox VE is using the Linux network stack. The configuration can be done either v...
Proxmox VE 9.0 - Configuring Management Interface with Routing at OPNsense
Introduction The goal here is to configure Proxmox to have a management interface in the VLAN 10...
Information Reference
How to set the config-register on a 2960https://community.cisco.com/t5/routing/how-to-set-the-con...
Converting a Cisco Lightweight Access Point Back to Autonomous Mode
Introduction The AP used in this lab is a Cisco Aironet 1700i Series AP, an AIR-CAP1702I-E-K9. ...
Reset Cisco Aironet 1700 Series LAP to factory defaults
Introduction For this lab I have the following AP model: AIR-CAP1702I-E-K9. This is an AP I boug...
Configuring an autonomous Cisco 1700 Series AP via CLI
Introduction We begin where we left off in the article of how to convert a lightweight AP (LAP) ...
Lab 10-1: Troubleshooting WLAN Connectivity
Lab 7-2: Configuring WLAN Security
Cisco UC500 Lab #1-1: Introduction and initialization using CCA Telephony Setup Wizard
Introduction On the previous pages of this chapter, the Cisco UC500 was introduced, factory rese...
Introduction to the Cisco UC500
Introduction Cisco’s UC500 is a purpose built appliance for SMB (Small and Medium Business) solu...
Setting up Cisco UC500: factory reset, initialization, and connection to CCA
The Cisco UC500 appliance was introduced on the previous page Introduction to the Cisco UC500. I...
Cisco Configuration Assistant 3.2.3: requirements, setup and how to use
Cisco Configuration Assistant (CCA), part of the Cisco Smart Business Communications System (SBCS...
Steps for recovering a UC500 from ROMMON
First thing, we want to remember that the UC500 appliances do not have a dedicated onboard, non-r...
Cisco UC500 Lab #1-3: Configuring a SIP trunk on UC500
Introduction On previous chapters we initialized the UC500 using the Telephony Setup Wizard on t...