Recently Updated Pages
Reset Cisco Aironet 1700 Series LAP to factory defaults
Introduction For this lab I have the following AP model: AIR-CAP1702I-E-K9. This is an AP I boug...
Configuring an autonomous Cisco 1700 Series AP via CLI
Introduction We begin where we left off in the article of how to convert a lightweight AP (LAP) ...
Lab 10-1: Troubleshooting WLAN Connectivity
Lab 7-2: Configuring WLAN Security
Cisco UC500 Lab #1-1: Introduction and initialization using CCA Telephony Setup Wizard
Introduction On the previous pages of this chapter, the Cisco UC500 was introduced, factory rese...
Introduction to the Cisco UC500
Introduction Cisco’s UC500 is a purpose built appliance for SMB (Small and Medium Business) solu...
Setting up Cisco UC500: factory reset, initialization, and connection to CCA
The Cisco UC500 appliance was introduced on the previous page Introduction to the Cisco UC500. I...
Cisco Configuration Assistant 3.2.3: requirements, setup and how to use
Cisco Configuration Assistant (CCA), part of the Cisco Smart Business Communications System (SBCS...
Steps for recovering a UC500 from ROMMON
First thing, we want to remember that the UC500 appliances do not have a dedicated onboard, non-r...
Cisco UC500 Lab #1-3: Configuring a SIP trunk on UC500
Introduction On previous chapters we initialized the UC500 using the Telephony Setup Wizard on t...
Cisco UC500 Lab #1-2: Configuring basic system settings
Introduction Below is a concise checklist of the basic system‐level settings we should configure...
HP ProLiant ML350 Gen10
Tower dimensions (H x W x D): 46.25 x 17.4 x 64.8 cm Tower weight (approx.): 21-42 Kg Su...
Lab 5-1: Basic Manual Phone Configuration Using the CLI
With previous labs building the foundation for telephony concepts and a network topology, it is t...
Lab 4-2: Configuring Link Aggregation (LAG) on the WLC
Topology Task 1: Explain Link Aggregation Link aggregation (LAG) is a partial implementatio...
Lab 2-1: WLC Basic Setup and Management Interface
Topology Task 1: JRI.WLC.01 Bootup, Factory Reset First task is to bring the JRI.WLC.01 550...
Lab 3-1: Join Process - Configure and Register Lightweight APs
Topology Task 1: CAPWAP Exploration Cisco lightweight access points use the IETF standard C...
Lab 6-4: Call Processing, Dial Plans, and Digit Manipulation
Equipment Required No equipment is required for this lab. Learning Objectives Upon completion ...
Appendix E: PSTN Simulator
Introduction The PSTN Simulator is a Cisco router (a Cisco 2821 in this lab) with one or more T1...
SD-WAN
https://cloudmylab.com/services/learning-labs/cisco-sd-wan
Lab 6-7: Quality of Service (QoS)
Topology diagram Equipment Required Cisco 2821 router Cisco 3560 switch Lab configuration...