Recently Updated Pages

1. Underlay vs. Overlay: The Core Architecture An SD-Access fabric works by running a virtual log...

1. Traditional Campus Network Challenges Managing legacy enterprise networks introduces massive o...

Topology Addressing Table Device Interface IPv4 Address IPv6 Address IPv6 Link-Local R1 G...

Topology Addressing Table Device Interface IP Address Subnet Mask R1 G0/0/0 172.16.12.1 255...

Topology Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 S0/1...

Topology Addressing Table Device Interface IPv4 Address R1 G0/0/0 172.16.0.2/30 G0/0/1 10.10.0.1/...

Topology Addressing Table Device Interface IPv4 Address R1 G0/0/1 10.10.0.1/29 Loopback0 209.165....

The Problem: Multicast Across Different Internet Companies In a single network, PIM Sparse Mode u...

The Problem with Regular PIM-SM (Many-to-Many Apps) In standard PIM Sparse Mode, routing is unidi...

What is Source Specific Multicast (SSM)? In standard PIM Sparse Mode, a host joins a group using ...

Rendezvous Point (RP) Deployment Methods A Rendezvous Point (RP) is a router that serves as the c...

Multicast Forwarding vs. Unicast Forwarding Unicast Forwarding: A router looks only at the destin...

First, a quick and critical correction regarding the previous discussion about notation: IGMPv3 i...

The primary purpose of the IGMP is to permit hosts to communicate their desire to receive multica...

Multicast is used to send the same data packets to multiple receivers. By sending to multiple rec...

Proxmox VE is based on Debian.  The installer will guide you through the setup, allowing you to p...

Introduction This device is a  fanless network appliance and soft router often sold under various...

Topology Objectives Part 1: Build the Network and Explore Dynamic Trunking Protocol Part 2: Confi...

Topology Addressing Table Objectives Part 1: Build the Network and Configure Basic Device Setting...

Topology Addressing Table Objectives Part 1: Build the Network and Configure Basic Device Setting...