Recently Updated Pages
Lab 6-2: Configuring Radio Resource Managament (RRM)
Topology Task 1: Information about Radio Resource Management The Radio Resource Management ...
Lab 6-1: Configuring 802.11 Support and Data Rates
Topology Task 1: Configuring 802.11 Support Cisco WLCs and most APs can support WLANs in bo...
Lab 4-5: Configuring Backup Controllers and Redundacy (N+1 and N+N)
Topology Task 1: APs WLC selection Once an AP has finished the discovery process, it should...
Lab 4-4: Joining APs to JRI.WLC.02
Topology Task 1: Modifying DHCP Server Option 43 at JRI.EDGE This lab is just to verify tha...
Lab 4-3: Updating the WLC Image and AP Bundle (GUI method)
Topology Task 1: The Need for Upgrading JRI.WLC.02 This page will show the upgrade process ...
Lab 4-1: Adding a Second WLC to the Lab (CLI Configuration Wizard Method)
Topology Task 1: JRI.WLC.02 Bootup, Factory Reset We have already setup the JRI.WLC.01 (whi...
Lab 2-2: Management of Controllers (5508)
TopologyTask 1: Using the Controller InterfaceUsing the Controller GUIA browser-based GUI is buil...
Lab 1-2: Configure the Management Server
TopologyTask 1: Cable the Management Server to JRI.EDGEThe Management Server will be given a fixe...
v1.0 - Initial CCNA Wireless study topology
Introduction This is the initial version of the network topology, specially crafted for testing ...
Cisco 5500 WLC - Cisco WLAN Express Setup
1. Connected the WLC to the PC via console. Entered the bootloader and selected option 4: 2. C...
Key notes on Network Fundamentals
Same-layer interaction: The two computers use a protocol to communicate with the same layer on ...
RF Signals and Modulation
Wireless data must travel through free space, without the constraints and protection of a wire. I...
Lab 15-2: Troubleshooting CUCME Configuration
Topology diagram for this lab Equipment Required Cisco 2821 router Cisco 3560 switch Thre...
Lab 7-3: Configuring Call Detail Records and Accounting
Topology diagram Scenario JRI needs to get information about calls placed on its phones. Ther...
Lab 15-1: Troubleshooting Process (CUCME)
Equipment Required None Objectives Use Cisco troubleshooting methodology. Verify the phone ...
Lab 7-2: Configuring Call Forwarding
Topology diagram Scenario JRI wants to have calls redirected by the user from the phone and a...
Lab 7-1: Configuring the Phone Directory
Labs in previous chapters established the ability to call between phones in a company and to the ...
Lab 6-6: Dial-Peer Configuration Using CCP
Topology diagram for this lab Scenario Jimenez Research Inc. (JRI) wants to connect to custom...
Lab 6-5: Dial-Peer Configuration Using the CLI
Topology diagram for this lab Scenario Jimenez Research Inc. (JRI) wants to connect to custom...
Lab 6-3: Call Legs, Dial Peers, and Wildcards
Equipment Required No equipment is required for this lab. Learning Objectives Understand the...