UC500 Lab
Exploration of some of use cases for the UC500 appliance.
1 - Getting Started with SBCS
Cisco Configuration Assistant 3.2.3: requirements, setup and how to use
Cisco Configuration Assistant (CCA), part of the Cisco Smart Business Communications System (SBCS...
Introduction to the Cisco UC500
Introduction Cisco’s UC500 is a purpose built appliance for SMB (Small and Medium Business) solu...
Steps for recovering a UC500 from ROMMON
First thing, we want to remember that the UC500 appliances do not have a dedicated onboard, non-r...
Setting up Cisco UC500: factory reset, initialization, and connection to CCA
The Cisco UC500 appliance was introduced on the previous page Introduction to the Cisco UC500. I...
Cisco UC500 Lab #1-1: Introduction and initialization using CCA Telephony Setup Wizard
Introduction On the previous pages of this chapter, the Cisco UC500 was introduced, factory rese...
Cisco UC500 Lab #1-2: Configuring basic system settings
Introduction Below is a concise checklist of the basic system‐level settings we should configure...
Cisco UC500 Lab #1-3: Configuring a SIP trunk on UC500
Introduction On previous chapters we initialized the UC500 using the Telephony Setup Wizard on t...
2 - Establishing a VPN Tunnel between UC500s
Lab 1 - Prepare Both Sites Individually
Section 1: Addressing Plan and Telephony Setup Wizard In this section we are only defining the IP...
Lab 2 - Addressing, Routing and NAT
The purpose of this lab is to understand the traffic flow before we build the VPN: what gets rout...
Lab 3 - First Site-to-Site IPsec VPN
In this lab we are going to build the first VPN between both UC540s using Cisco Configuration Ass...